Building an Antenna

This is how a quality CNC machined long lasting antenna is manufactured. Starting at the top..Delrin lower coil support with .750 inch of oil lite bronze for a nut, 3/8 inch Stainless allthread, threaded clamping collar, bearing housing with two double sealed ball bearings, threaded clamping collar, magnet support ring/motor coupling, Delrin motor support housing and finally the Industrial grade Pittman motor.

We use only the finest materials in our antennas. Our customers are amazed at the machining and how well they are built. Our antennas cost more to manufacture than the other guys but we know our antennas will be around for many years to come.

We are the only Antenna manufacture that will show the public the inside build of our Antennas....We Hide Nothing....A few photos are worth a Thousand Words!
Quality built Inside and Out!
Proudly Made In The USA!

Below is a chart on how strong the Delrin is we use.

Tensile Strength (psi) 9,500
Tensile Modulus (psi) 400,000
Tensile Elongation at Break (%) 30
Flexural Strength (psi) 12,000
Flexural Modulus (psi) 400,000
Compressive Strength (psi) 15,000
Compressive Modulus (psi) 400,000
Hardness, Rockwell M88 / R120


Over built! You bet! Pressed in .750 inch long Oil lite bronze nut that is also retained by a set screw. This will outlast anything on the market today	Coil support bearing housing. We are the only manufacture to install two double sealed ball bearings for the coil support.	SA-680® Stainless counterpoise bolts at base of antenna makes it a snap to connect counterpoise wires for home use, field day or camping.

SA-680 Finger stock housing mounted on antenna.	Inside view of our finger stock housing with coil support. Precision machining through out. Quality you can expect from Scorpion Antennas	Scorpion finger stock housing top view.

Scorpion precision machined coils upclose. SA-680 "left" SA-6160 "right".	With the Scorpion Quick Disconnect System® you are able to transfer your antenna from your auto to your backyard tripod and be on the air in less than 5 minutes.	The Scorpion Quick Connect Stud® is a massive 4 inch long by 1.3 inch Dia. 6061-T6 Aluminum. It is the strongest in the industry. Shown partially installed. Note: Antenna retaining groove in stud for antenna lock down bolt through counterpoise ring.

This is our CNC precision machined finger stock and coil support housing. This 3.5 inch long Aluminum housing is also a heat sink under high power use.	We use Tin plated finger stock on all of our antennas. Our finger stock has a combined pressure of 37 lbs on the coil, highest in the industry.	Scorpion precision machined coils upclose. SA-680® "left" SA-6160® "right".